The 3D chamber is the ceramic heating cup that screws into the base of the Puffco Peak by hand. Heating elements run through the ceramic walls, so heat reaches the concentrate from all sides at once. Material that spreads or splashes onto the walls during a draw gets vaporised there.

Ceramic wears down over hundreds of heat cycles, and this chamber is the one part of the Peak designed to be swapped out. With a second one on the shelf, the vape stays available while the other soaks in isopropyl and air-dries fully. Flavour is the signal to change: a darkened chamber floor is normal, a change in taste is not.

The threading is specific to the Peak. Chambers from other Puffco models do not fit here, and this one does not fit them.

Intended for use with: Puffco Peak.